This is a typical situation that you put the stairs, watching TV or reading a book and you hear a big bag from the floor. Alarmed, he rushed to see what happens, and you can see the child's leg, arm or head-and-paste from the wall. After all the dust, so make sure everything is in order, and the appropriate punishment is divvied out, it's time to face the hole in the wall.

Now, depending on the size of the hole in the plaster. dependsas will be corrected. If you have a small door handle hole size will be easier to do so in a way (which ill explain later). But if you have a larger hole may be easier to install a new large piece of plaster, which extends from a pin to another. Let me explain that too.

Now, with a smaller hole, then we cut the pieces, which hangs over everything. We will do it with a plaster saw and a knife. So, when we have a nice clean space to workwith, we want to take in about 1/2inch to 1 inch strip of paper from plaster to look like cardboard torn. Then we cut a piece of plaster, which is slightly larger than the hole, which will result. Dan began to cut away the back of the piece until the piece to open and adjust the paper is left. This piece is called a patch "hat.

Now put mud plaster on the edge of the patch, hat and place it in the hole. Then again, instead of applying a layer of mudThe patch, allow to dry. When dry, break off the crumbs and sand smooth, and then back to mud. Let it dry and do the same thing. Do this until the patch is clean and smooth and ready to be baptized.

This is a small hole in the repair of plaster. Time to establish a larger hole, which is basically the same except that we go to the hole, cut off completely. Take the cast saw and cut up to become a procession, which now must be measured at least ¾ of an inch, so youhalf of the parade. Create two points and snap a line, or with the flat edge draw a line through the two points is the line you want cut. Now that you've done, we want to use the cut stud to the other side of the hole. Make a measurement from the same place that you're not the other way and add ¾ of an inch in. What do you get the other half for the parade. Two things, an A-line passes through it. With a framing square of the line using a line connecting the square to the topand bottom of the hole. You need a square hole now. Now you can cut the piece that you've noticed. Measure the distance that you have and cut a piece, so it is not true. When sliced Place the piece into the hole and pin on both sides where the sprouts are a couple of pen chalk. So it's like mud in the second instance, and you're ready. These are some examples of how to repair a hole in the wall.